Do it online
Have your say
Rubbish and recycling
Tonoa tuihonotia tētahi hononga ratonga (SCA)
Note: A site plan must accompany this application (see the "Attach required documents" section)
For further details on flow rates refer to Aus NZ Standard 3500
Your selection in this section requires the installation of a backflow prevention device. See the backflow prevention requirements section at the end of this form.
On-site effluent treatment systems shall be designed and installed in accordance with Bay of Plenty Regional Council requirements. Ph: 0800 368 267 for further info.
Trade Waste Consent is required for any Wastewater discharge from a trade activity. Contact TCC Trade Waste Officer for further details. Ph: 07 577 7000.
The vehicle crossing shall comply with IDC drawings T430, T431 and T432.
If during the course of construction, it is necessary for Council assets to be relocated, then the required work will be carried out at the owner’s expense.
Note: Existing manholes, hydrants and valve boxes may be located in new crossings, but must be re-levelled so as to be flush with the new surface. In the case of a fire hydrant, the clearance between the top of the spindle and the underside of the cover must be maintained between 100mm minimum, and 250mm maximum. This work MUST be carried out by one of Council's Licensed Contractors.
Backflow prevention requirements:
Find out more about backflow prevention.
Read the backflow prevention fact sheet.
Application site plans:
Allowed file extensions: .pdf, .doc, .docx, .jpg, .jpeg, .png. Maximum file size: 20 MB.
Was this information helpful?
+64 7 577 7000
Subscribe to our Newsletter